When you listen to music or karaoke, you feel speaker phenomenon being shy, but do not know why. Do you think the speaker is damaged, or broken parts that. Maybe you brought for repair or warranty. However, before doing that, you should check each device sounds in his orchestra. You check the wiring, the first jack, amplifier, mixer, …
The common reasons causing the speakers being shy.
- Speakers often howling microphones being shy by long: term phenomenon microphone howling very serious impact on quality of speaker sound. Hu as many speakers as perishable. A howling in 5 seconds treble speakers can understand that it is about 10 times the energy emitted by a green English hit consecutive original 0.5 seconds 1 times. Whenever microphone howling, loud speaker coil heat faster than normal and many times, it often does not heat up and emit environment affecting the surrounding parts of speaker wire.
- Speaker being shy because you divide the crossover frequency irrelevant: Crossover frequency filter sound speakers. The division crossover inappropriate great influence to which speakers emit sound. If you regularly to false crossovers, speaker will be timid. Before installing the audio frequency filter, you need to thoroughly understand the technical specifications of the speakers to ensure correct installation.
- Speakers shy due to overcapacity: You have a habit of loud-speakers enable speakers to make strenuous activity and may cause a fire long your speakers. You need to know the maximum operational capacity of adjustable speaker and frequency of use so that reasonable action to help speakers longest and most good.
- Speakers shy because you frequently use EQ: EQ is a device designed to alter the nature sounds to sound when passing. When you increase the treble and bas, but down mid the speaker system you will be overwhelmed in the mid, but in reality is not enough volume you have to remember that EQ can.Luon much part of what used to cut surplus, not increase what lack (preferably cut what balance). Currently, By almost every modern speakers have used this device to optimize the audio output system. However, if you use the EQ to adjust the sound is not the right way, you will make the speaker sound broken and emits being shy.
- Speakers shy because you use Compressors and limiters improperly: Normally, Compressors and limiters are devices used to adjust the sound effects help to reduce the variation in volume. Two devices can work very well for speakers, but if you do not know how to use, they can backfire and make your speakers being shy.
- Speakers shy because you open off improperly manipulate the process: The open off improper procedure is very common error but very bad consequences for the speaker. When you open off improperly, your speakers will have a sudden loud bang negatively affect the sound output system. You should absolutely avoid when no off Unplugging speakers as this could damage your speakers quickly than ever before.
- Amply is overloaded: The power of the amplifier is not enough capacity to meet the Speaker may cause the speakers being shy. The power of the amplifier is ideally greater than 2 times the average power of the speaker. Assuming a power amplifier with 100W average, the system usually has its maximum capacity would be 400W. Therefore select 200W power amplifier can be ideal.
- You happen to sudden loud bang: We must always adhere to the following principles: open from top to duoi.Con when disabled, from bottom to top (when open, open end cung.Con Power turns off, you Power switch off first). Especially, avoid Unplugging, touching wires, drop the mic, loud noises … caused while the audio system is active. To be safe in open off the wrong, we should use the power adapter sequence. So buy rope, jack type well and the welding wire in Iraq also requires skillful hands, when rotated, then sprinkle with 6 cups best to sort them out.
- Signal Mixer and the Effect overload: When you install signal Mixer and the Effect of Improper speaker also cause a negative impact to the speaker and makes speakers emit hiss or boiling. You must adjust the Gain only. This is related to sound quality, the best doctors to observe where noted not been clipping (or peak, or is overloaded), the words are often located next signal red lamp. The signal system overloads caused distortion, broken English. This adversely affects the system you are in high-quality sound.
- Speakers phenomenon ball down but continued to use: If you see your speaker fails, you should immediately fix and repair. If you hear the sound timid or small at the best time to check the speakers before further use. That was the prelude to a speaker system you are having problems to be overcome shortly. This not only helps the speaker system is always stable performance but also improve your sound quality.
How to overcome the speakers being shy:
- Regularly check the loudspeaker by hand gently pressed diaphragm, repeated several times. If you do not see the phenomenon of friction means that your speaker is normal.
- You check portion taper tube speaker wire and magnet core has been touched or not.
- You check the speaker cone center for movement or not.
- You carefully check the joints between the diaphragm and the speaker cone, between the diaphragm and the speaker spider if there is open or not. At the same time, you check with the speaker cone part dirt or an object that falls on or not.
- You check the wires from the wire section on the diaphragm speakers.
- Hopefully these notes will help you overcome being shy speaker status.
- Check shy so torn diaphragm, relaxing by the water is wet, do eccentric cone speakers.
- Check insects like bees tha hybrid enters nesting ground, causing jams cone speakers.
- Check back timid by conductor speaker wire into the membrane from the station about to snap off.
Want your speakers stable performance and long-term use, you should regularly check, negate the fastest try to give your sound system is working well. Depending on the intended use, you should select the most appropriate device. Do not use the karaoke equipment to listen to music or vice versa.
If you have questions, or need assistance, you can contact me with Phan Nguyen Audio.